Electric Meter Replacement
Scorch marks around the meter, a mast pulling away from the fascia, or a red tag from the utility all point to the same job: the service equipment needs replacing, not patching.
Electric Meter Replacement in Palmdale and the Antelope Valley
The meter socket, service riser and mast are the handoff point between the utility and your home — and when they corrode, pull loose or burn, the whole property is at risk. Nebady's Electric Corporation replaces damaged meter mains and meter sockets, repairs and re-anchors service masts, and works directly with the utility so power is restored correctly and safely the first time.
Nebady's Electric Corporation is a licensed electrical contractor based in Palmdale, California. Every job starts with a free written estimate, is carried out to the California Electrical Code, and ends with a walkthrough of exactly what changed — whether that is a single circuit or a full service upgrade.
What this service covers
- Meter socket and meter main replacement
- Service mast and riser repair or re-anchoring
- Damaged or burnt service equipment replacement
- Overhead to underground service conversions
- Utility disconnect and re-connect coordination
- Red-tag correction and re-inspection support
Four steps from first call to sign-off
On-Site Diagnosis
We inspect the meter socket, mast, weatherhead and grounding to identify exactly what failed and what has to be replaced.
Utility Coordination
We arrange the disconnect with the utility and schedule the work so your household is without power for the shortest possible window.
Equipment Replacement
Old socket, mast and damaged conductors come out; new, correctly rated equipment goes in, properly sealed and grounded.
Reconnect & Verify
Power is restored, every reading is verified, and we confirm the installation is ready for inspection before we leave the site.
Electrical work is the one trade you cannot see failing
A loose connection behind a cover plate gives no warning until it does damage. Doing this work correctly is not about finish quality — it is about what never happens afterwards.
Code-Compliant Work
Every circuit, conductor and connection is installed to the current California Electrical Code — not to whatever was acceptable decades ago.
Capacity That Lasts
We size the work around how your property is actually used, so it still holds up when you add A/C, an EV charger or a new appliance.
Failure Points Removed
Loose lugs, corroded terminals and overheated breakers are the causes of most electrical fires. We find them and replace them properly.
Answered 24/7
Electrical faults do not keep business hours. We answer around the clock and treat burning smells and dead service as emergencies.
Measured, permitted, tested
These are the habits that separate an installation that passes inspection from one that is still sound in twenty years. They apply to every job we take, at every size.
Load Calculation First
We measure before we quote, so you buy the capacity you need — not the capacity that is easiest to sell.
Written Estimates
Itemised scope and pricing in writing before any work starts. No verbal numbers, no surprise line items.
Torqued & Labelled
Every termination is torqued to specification and every circuit is labelled, so the next electrician inherits a clear panel.
Permits & Inspection
Panel, meter and service work is permitted work in LA County. We prepare the paperwork and coordinate inspection.
Tested Before We Leave
Every circuit we touch is energised, tested and walked through with you before the truck pulls away.
Electric Meter Replacement — questions, answered
Get a free estimate for electric meter replacement
Tell us what the property needs. We'll come out, run the numbers, and put a clear price in writing — 24/7 · always open.